In a plastic injection mold, the mold opening action is leveraged to create a relative movement trend between the angle pin and the slide, so that the slide moves in two directions – the mold opening direction and the … Section 2: Slides/Lifters Standards and Design. How the slide work in plastic injection mold? Contents: A) Mechanical injecion mold Slide Design Standards B) Hydraulic injecion mold Slide Design Standards B) Injection Mold Lifter Standard A) Mechanical injecion mold Slide Design Standards (refer to drawing S2-1 & S2-2): 1) All shut-off surfaces must have a minimum of three degrees draft in direction of slide travel. Side action molds can contain complex molding surfaces or simply a pin to create a hole. A selection of Slide Retainers offer simple and positive operation that work well with new tooling designs or retrofitting existing molds. In injection molding the use of cam-action slides in injection molds is the most common and most efficient method to cast any type of undercut on a plastic part.. During the initial design stage, the first thing that is looked for on a part print or a solid model is to determine the parting line and if there are any undercuts present. The movement of the side actions can be controlled with angle pins or delta cams. The side actions in Pelco molds are built with plenty of locking force to ensure a clean seam line without any unwanted flash.

United States – 800-626-6653 Canada – 800-387-6600 Europe – 32-15-215011 Asia – (86-755) 8601-9031 Whether reducing frictional wear, preventing mold damage or extending service life is your objective, DME slide action components are an asset to your molding operation.